| Great Value J Foo |
| Pleased with servos, no chatter, horns fit the mini titan without any modification. it even works with Futaba gyro's DS mode. Can't ask for more from a 10 dollar servo. Looking for excuses to buy more. Need more planes and helis |
| ___________________ |
| Arced Digital Micro Servo 1.3k Reimer Pehrs |
| Echt nicht schlecht dieses Servo.Richtig schnell,trotzdem Kraft ,vor allem die haltekraft �berfordert das Getriebe fast.Absolut kein Spiel am Ruderhorn,spitzenm�ssig!!Habe wirklich nur aus Neugier gekauft und bin fast schon begeistert,Servo l�uft sehr gut am Kreiselkompass. Ein Ersatzgetriebe ist auch noch dabei,das alles f�r 10$.... |
| ___________________ |
| Review Richard Parkes |
| Smooth, powerfull, great price what more could one ask for. Fitted to my EPP 3D biplane ailerons and working well. |
| ___________________ |
| Arced Digital Micro Servo 1.3k Panayotis Pantazopoulos |
| Awesome digital servo. I get 4 to test, looks nice. I would use then at mi mini titan as cyclic and maybe as a rudder control servo. Very good torque, quick enough, light weight and very very cheap. In my country the analog servos are more expensive than this one. I will give you a new review after the test. |
| ___________________ |
| ok ronald burrows |
| i got 3 servos for the titan great servos but found that when used on ccpm they over run once past the 100% mark advise do not use in ccpm helis Ron |
| ___________________ |
| Arced Digital Micro Servo 1.3k Raymond McMaster |
| I got 4 of these and tested one to destruction. The power is good and they hold position very well. Speed is good and accuracy very good for such a cheap servo. One word of warning .. the DO NOT like to be driven too far, setting end point above 100% causes strange effects like the servo will jump a long way and the final position is not repeatable. This means take great care if you fit them to cyclic on a ccpm heli where there is large travel they will NOT WORK. :ike all micros, the gears did strip when I pushed it hard but they come with spares so easily fixed. |
| ___________________ |
| servo Frode Karlsen |
| Har pr�vd denne p� Mini titan B�de p� rotor og hale Fungerer utmerket |
| ___________________ |
| Arced servo 1.3 Jordan Lyall |
| Little guys try very hard to do a good job, somewhat noisy, but quite good. Just don't max out your servo travel adjustment. I could get about 135% of 150% on my radio before the servo would create it's own end point. Great speed, and surprising initial torque. |
| ___________________ |
| Arced Digital Micro Servo Feddo Wouters |
| Very good tail-servo for Honeybee King V2 helicopter. |
| ___________________ |
| Arced Digital Micro Servo Panayotis Pantazopoulos |
| Tested and is very good and precise for the price. Recomended for precese low cost servo applycations. In my country same size analog servo is much expensive. |
| ___________________ |
| ARCED 1.3kg 0.9sec micro servo Terence Chan |
| Really DS-compliment. Don't know how long it will last yet but 1st impression is very good when used on a 450-size heli for rudder. -Terence |
| ___________________ |
| Arced Digital Micro Servo 1.3k John Freeman |
| Excelent little servo, purchased quite a few already, plan to get more |
| ___________________ |
| nice servo for heli scope |
| i use this servo on my copterx as a tail servo. works good also in gy401 digi mode. recommended. |
| ___________________ |
| Arced Digital Micro Servo 8.5g Mike Roberts |
| Fitted this to Zoom type heli with Futaba 401 gyro in DS mode. All works well. Response is precise and smooth. Will be getting some more. Mike |
| ___________________ |
| Great Servo! John Hatzidakis |
| I use this in my trex 450, the tail is even more rock solid with this servo than the old HS-50 I used to have in it. |
| ___________________ |
| Great, with limitations msX |
| Great servo for that price, but doesn't work at 6V (4 AA batteries) and the servo way is limited to 135%. Gutes Servo zu dem Preis, leider funktioniert das Servo �berhaupt nicht an 6V - also 4 Mignon Batterien. Bei 5V (was die meisten BECs haben) gibt es jedoch keine Probleme. Die Wege sind auf 135% (sicher 125%) (Graupner/JR Wege) limitiert, daher nicht geeignet f�r Delta-Modell (FunJet z.B.) Stellgenauigkeit ist digital-like super, die Anschlusskabel sind etwas kurz. Verarbeitung ist noch gut. Leider noch keine Langzeiterfahrungen vorhanden. |
| ___________________ |
| Arced Digital Micro Servo Olaf Virk |
| Quick, strong and low max current(200mA)- really frequency conversion digital servo. But max pulse width is 2ms, after this the servo steps to end. Like potentiometer center and servo 1.5ms positions are not same. Maybe it's occasional defect. I have only one servo. |
| ___________________ |
| Acred D591 Michael |
| I purchased 3 of the D591 servo and so far very happy with the performance and the value. It replaced my HS-81 on the tail of my Trex paired with a GY401. The D591 did work in digital mode but the tail seemed to hunt. Will try again on a different heli setup. The D591 did very well on my small aircraft setups...just do NOT over drive them (as stated in other reviews) |
| ___________________ |
| Arced Digital Micro Servo 1.3k blaz vodopivec |
| Very good digital servo for the price. Quick, strong, centers well, holds position, no glitches, much better than Corona. Less resolution than top digital servos, but hey, they cost four times more. |
| ___________________ |
| D591-v3 Georg Romanski |
| Nice little Servo. Works great and centers well. Give it 4 Stars because it will not work with my 2 Futaba R606FS receivers. All my other receivers: no problems. Bought 4 pcs. |
| ___________________ |
| Titan.. nizam kamarudin |
| Excelent little servo for my rudder control servo. Good price!! |
| ___________________ |
| D591-v3 Digi-Micro Servo Christoph Priess |
| Theese are GREAT! You get such a precise and fast Servo for a price you won�t believe. They center very well, are strong on 4,8V. I didn�t try them on 6V by now, but here are some guys warning they won�t do it on 6V. I�ll tryout and tell you. But even if they just handle 4,8-5V- you get a lot for little money! Thanx again HC! |
| 欢迎光临 5iMX.com 我爱模型 玩家论坛 ——专业遥控模型和无人机玩家论坛（玩模型就上我爱模型，创始于2003年） (http://bbs.5imx.com/) | Powered by Discuz! X3.3 |