[这个贴子最后由vidct在 2003/01/30 07:45pm 编辑]
最近我在研究这个产品：
http://www.mscomposit.com/Products/Hornet/hornet.html
Main rotor diameter (mm)
490
Overall length (without blades)
600
Model height (mm)
160
Weight (starting) g
240-280
Transmission rate
1:18:4
Tail rotor drive
carbon wire
Rotorhead
fixed pitch
Engine
Speed 300
Main rotor speed
up to 1500 rpm
Regulator
MS-Regulator, 5A, weight 9 g
Gyro
MS Modified CSM 180
Batteries
7xNiMH, 880mAH, 8.4V
Receiver
MS-Receiver 4-channel
Transmitter requirements
4-channel
Flight time
8-12 min
Packaging
Base HORNET Kit MS-100:
HORNET kit, not assembled, incl. main rotor blades
Speed 300 engine
Assembly instructions
Recommended accessories
MS-Receiver at least 4 channel
MS-Regulator, 5A, 9g
MS Modified CSM 180 piezo gyro
MS NiMH Battery pack for HORNET
MS NiMH Battery charger
3x microservo
Full HORNET Kit MS -1xx (xx for frequency range)
HORNET kit, not assembled, incl. main rotor blades
Speed 300 engine
MS-Receiver 5 channel* - 35, 40 or 72 MHz range
MS-Speed Controller BEC, 5A, 9g
MS Modified CSM 180 piezo gyro
MS NiMH Battery pack for HORNET, 700 MAh
MS NiMH Battery charger
3x microservo
Assembly instructions
* The receiver is modified - the 5 channel is tuned as 6th one for CCPM control!
Schweizer 300 Packaging:
MS-300 MS Schweizer 300 basic kit, analogue to Hornet basic kit
MS-301 MS Schweizer 300 upgrade - if you have Hornet already, this is the choice
MS-335 MS Schweizer 300 Full kit - all electronic included, for 35MHz range
MS-340 MS Schweizer 300 Full kit - all electronics included, for 40 MHz range
MS-372A MS Schweizer 300 Full kit - all electronics included, for 72 MHz range - Futaba
MS-372B MS Schweizer 300 Full kit - all electronics included, for 72 MHz range - JR
For details look at Hornet packaging - the concept is the same!
尾桨轴传动!
|
/1 
发表于 2003-1-10 17:21
收藏
楼主